2001 Chevy Malibu Door Panel Removal

Author Roy 10 Aug 2023

Pry off the bezel behind the door. Step 2 :removing the door panel. Web short video manual of door handle removalyou can also buy us a coffee! Web remove the power accessory switch panel.

How To Remove Front Inside Door Panel 200408 Chevy Malibu 1A Auto

Pry door handle plug by using small flat. Web disconnect the window switch wiring harnesses. Carefully lift the door panel up and off the upper lip of the metal door frame.

Web Double Check You Removed Every Screw Pictured, If So Then Stick Some Sort Of Pry Tool In The Lowest Part Of The Door Panel (That Way Any Small Scuff Or Mark Isn't Made In An Obvious Area).

Remove the front door trim panel by lifting upward on the armrest to disengage the panel clips. Web how to remove front and rear door panels on a 2021chevy malibu. I also show how to put the panel back on ( sometimes this can be tricky)

Remove Power Accesory Switch Panel By Using Suitable Flat Blade Tool At Front.

Use an 8mm wrench to disconnect the negative battery cable. Web tools needed are 10mm socket, 90 degree pick, wide nylon pry tool and a t 25 bit. Web the book says 1.

Remove The Door Switch Panel And The Control Switch Panel And The Control Switch.

Web here we have a 2017 chevrolet malibu tutorial showing the procedure and required tools to remove the front door panels. Web lift door panel off frame: Check out our facebook and instagram.

Web Step 1 :Disconnecting The Battery.

Pry the two clips out of the rear edge of the door panel with a flat blade screwdriver. Remove the two 7mm bolts behind the door. Lifting the top edge of the door panel will remove.

Pry Off The Trim Piece Behind The Door Pull With A Flat Blade Screwdriver.

Remove all door trim panel retaining screws and door pull armrest assemblies. Web disconnect the window switch wiring harness. Pry out the door panel with a.

2.4L Ecotec I4 Titanium Interior.

Web there are snap in clips around the sides and lower door panel that release by pulling straight out, or use plastic pry tool, then pull lower panel away from door and. Pry just enough to get your hand in there and just pull/yank hard!